configurations

Below are tested starting configurations for different trading styles. All settings not listed remain at their defaults.

Config 1: Balanced Default (1H Crypto)

Best for: Daily active trading on major crypto pairs (BTC, ETH) on the 1-hour chart.

Setting	Value
Enable Volatility	On
Enable Momentum	On
Enable Expansion	On
Enable Order Flow	On
Block Chop Zone	On
Chop Zone Low	35
Chop Zone High	65
Momentum Oversold	30
Momentum Overbought	70
Volatility Overbought	80
Volatility Oversold	20
Enable Long Dots	On
Enable Short Dots	On
Only plot on state change	On
Use Momentum Divs	On
Use Expansion Divergence	On
Use Order Flow Divergence	On
Min Divergences Required	1
Divergence Fresh Bars	20
Score Pillars	On
Base Min Score (Long)	2
Base Min Score (Short)	2
Regime Filter	On
Cooldown bars	10

Config 2: Conservative Swing (4H / Daily)

Best for: Swing trading with fewer, higher-conviction signals.

Setting	Value
All pillars	Enabled
Block Chop Zone	On
Chop Zone Low	40
Chop Zone High	60
Momentum Oversold	30
Momentum Overbought	70
Base Min Score (Long)	3
Base Min Score (Short)	3
Regime Filter	On
Cooldown bars	8
Min Divergences Required	2
Divergence Fresh Bars	40

Config 3: Momentum + Volatility Only (No Expansion, No Order Flow)

Best for: Assets with unreliable volume data (small-cap altcoins) or when you want a simpler, faster-reacting signal based on price action alone.

Setting	Value
Enable Volatility	On
Enable Momentum	On
Enable Expansion	Off
Enable Order Flow	Off
Block Chop Zone	On
Chop Zone Low	35
Chop Zone High	65
Base Min Score (Long)	1
Base Min Score (Short)	1
Regime Filter	Off (Expansion disabled)
Score Pillars	On
Use Momentum Divs	On
Use Expansion Divergence	Off
Use Order Flow Divergence	Off
Min Divergences Required	1

Config 4: Scalping (5m–15m)

Best for: Short-term scalping. Expect many signals — use other chart context to filter.

Setting	Value
All pillars	Enabled
Block Chop Zone	On
Chop Zone Low	30
Chop Zone High	70
Base Min Score (Long)	1
Base Min Score (Short)	1
Regime Filter	Off
Cooldown bars	3
Only plot on state change	On
Use Momentum Divs	Off
Use Expansion Divergence	Off
Use Order Flow Divergence	Off

Divergence is disabled in scalping mode because divergence detection relies on pivot points that take multiple bars to confirm — too slow for very short timeframes.

Config 5: Long-Bias Bull Market

Best for: Confirmed bull market conditions where you want aggressive long entries and selective shorts.

Setting	Value
All pillars	Enabled
Base Min Score (Long)	1
Base Min Score (Short)	3
Regime Filter	On
Block Chop Zone	On
Cooldown bars	10
Enable Short Dots	On (ignore low-score shorts)

Tuning Tip

Start with Config 1 and adjust from there. The single most impactful lever is Base Min Score:

• Too many signals → raise Base Min Score by 1
• Too few signals → lower Base Min Score by 1, or disable the Regime Filter